Have a look on my last project in progress, a 6'6"/18.75"/2.25" travel board for my mate JB.
Step 1:
Protect the deck, flip it and glass with bright yellow and 6 oz.
Step 2:
Almost dry? Cut the lap, watch out with UV resin..., right moment= perfect job, too late...mmmmh.
Step 3:
Protect the lap with tape and lay down the 6 oz, mix the turquoise tint into the white tint, mix it (3 strokes) and... go! Nice swirls, huh?
Step 4= step 2!
Step 5:
Here is my tip, even if the cut lap is nice, i fill the spaces between the laps with some resin. Once it's dry, i sand and i'm ready for the next step.
Step 6:
Cut some 4 oz for the logos and the FCS patches then glass.
Step 7:
On the deck i finish with some 4 oz, free lap with clear resin, don't forget the logos, and like usual 6 oz patches on the back third for maximum strenght. Once it's dry i pour some hot coat on the free lap, the patches, and sand. End of the glassing, here comes the hot coat!
vendredi 28 mai 2010
Inscription à :
Publier les commentaires (Atom)
Aucun commentaire:
Enregistrer un commentaire